testing tnt circuit blunt end probe

Blunt Probe as Per IEC60950, IEC60065 and IEC62368-1 for Testing TNT Circuit 1. Introduction The blunt probe is designed according to IEC60950 figure 2C, IEC60065 figure B1, IEC62151 figure 3, UL6500 figure B.1, IEC62368-1 figure V.3. It is applied to check if the exposed parts of TNT circuits of information technology equipment has adequate protection. 2. Specification Length of the probe 80mm±0.2mm Radius of probe R6＋0.05mm Diameter of probe

...Blunt Test Probe Of Figure V.3 Product information: The blunt probe of figure V.3 conforms to IEC 62368-1:2018 clause 5.3.2, 5.4.10, V.1.4 and figure V.3, IEC60950 figure 2C, IEC60065 figure B1, IEC62151 figure 3 and UL6500 figure B.1. It is used for the bare parts of TNV circuits of information technology equipment to see whether they have sufficient protection. Technical Parameters: Probe Length 80 mm Probe End

...Probe High Impedance Probe 200X Attenuation ±1500Vpk Measurement 5MHz Bandwidth CAT II 1000V Safety Key Features: Industrial-grade voltage support ±1500Vpk maximum differential voltage, designed for power electronics and industrial control systems. High input impedance 5MΩ single-ended to ground, reducing the impact on the circuit under test...

...Testing Electronic Connector​ Product Description : --- Spring loaded pin(single) for PCB , ICT , FCT testing , etc --- Pogo pin ( connector ) to establish a ( usually temporary ) connection between two printed circuit boards for charing , locating , Battery , Semiconductor & interconnect Applications --- Double ended probe or BGA & semiconudtion testing...