8.3A Constant Voltage 0 10V LED Controller With AC100V - 240V Input

Max 200W Constant Voltage 24V 0-10V Dimming Driver DM9118H-V24

SUMIRIZE:

This series is 0/1-10V dimmable drivers for LED strio and other constant voltage of constant current LED lights, we can offer not only DC input but also AC input products. No flicker on low brightness. We use logarithmic brightness curve to get smooth and good sense for eyes. They all compatible with products of Lutron, Dynalite, Clipsal, LDS, Osram, , ABB, Schneider, Levition, JUNG, Berker, Be Lichregler etc.

1, Single channel 200W constant voltage DC24V output dimming control.

2, No flicking, analog voltage DC 0/1-10V dimmer, passive 0/1-10 v dimming general to use, can with the large control system structure to dim.

3, From 0 ~ 100% to dimming.

4, Dimming curve difference between products can be adjusted by adjustable resistance

5, With the self-test function, support short circuit , over current and over heating protections.

6, Custom-made is available and 3 years warranty.

Tech-parameter:

Product Size

Specifications of 0/1-10V LED Dimmable Driver Series:

Function Instructions:

1), According to the product connection diagram,active 0/1-10V voltage regulator,or passive 1-10V dimmer, LED load, power by positive and negative to connect to the right port, open the power supply, adjust the 0/1-10V voltage regulator, so as to change the output of the controller, until get the satisfactory of LED output brightness.

2), Please choose AC100-240V power input and don't exceed th max 200W output load. Check input voltage avoiding damage before power on.

0/1-10V System Connection Notes:

1. Please use the voltage 0/1-10V dimmer curve,otherwise it will smooth dimming directly impact LED. otherwise it will smooth dimming direct impact LED.

2. LED load voltage and controller of power supply, all must be in the input voltage range specified in the product.

3. Before dimmers powered in, check all input and output interface connected correctly (AC”L”,”N”, ground, and DC output “+” “-“), 0.75mm2 copper is recommended; for the security use and reduce interference, make sure the ground terminal reliably grounding.

Product Online:

0/1-10V Dimming System Wiring Diagram: