P2 Polyurethane Spray Gun 0.4 - 0.8Mpa Air Inlet Pressure For
Exterior Wall Insulation
|Max.fluid working pressure||24Mpa|
|Air inlet pressure||0.4-0.8mpa|
|Cleaning method||self cleaning with air|
|Mix Chamber Size||1.3mm(1.5mm could select)|
|Spray nozzle size||1.6mm(1.8mm or 2.0mm could select)|
|Spray gun parts||Could send the total part list about the spray gun for extra select|
P2 gun lightweight, easy to handle , even in the difficult position
of spray can and spray ease of operation , its excellent production
efficiency has been widely recognized by the industry . At the end
of the work day , maintenance is simple. P2 gun with one-way valve
to separate the wet area of the gun .
trigger rapid response - double piston provides a powerful driving
replacement of the mixing chamber can insert , without replacing
the entire mixing chamber .
Anti- crossover design to virtually eliminate the possibility of
material fleeing into the air piston.
ergonomic handle design for peace and comfort , compact , and
1. The pipe joint Angle, reduce the gun load, make operation easy.
2. Gas valve can prevent trigger is stuck.
3. Gas auxiliary spring can quickly cut into the mixing head of raw
4. Jet linear continuous and smooth, no field control.
5. Pneumatic wrench can reduce the labor intensity of operators.
6. All steel hybrid head, output, precise control of spraying
position, reduce the waste of raw materials, particularly
applicable to residential construction between two walls of
7. Single valve device can prevent ISO material and POLY material
flow back, and not apart gun, which can check the gun inside most
of the seal.
8. Use manual switch valve, no tool can quickly and easily switch
9. High pressure vacuum mixed to ensure the best
Building exterior wall, cold storage, automobile, chemical storage
tank, workshop workshop, grain depot, farm shed and so on.