water cutting abrasive sand removal system is dedicated to cleaning
waste sand for water cutting equipment. The equipment break through
the traditional waste sand to clear the various problems, in
international and domestic market it is the most effective, most
convenient, most simple water cutting grit removal system.
CS-046-type abrasive sand removal system features:
1. not affect normal waterjet cutting work
The abrasive sand removal device can also work when the water jet
cutting machine is working.put the sand suction nozzle into the
waterjet tank, abrasive sand removal work can be carried out. At
the same time it will not affect the completion of Desanding
waterjets work properly. The device is fully avoid the traditional
sand must be shut down, the water tank must be drained, after
exhausted sand you need to fill with water again in before.
2. Simple operation, sand removal thoroughly, very fast
The device requires only five steps in the operation can be
completed Desanding: 1, equipment in place → 2, turn on the air
supply → 3, the sand suction nozzle into the tank → 4, turn on the
gas source switch degritting → 5 After sand full stop dumping waste
sand. Desanding rate of the device at more than 90%, if the Sand is
much, but mud and other impurities (plastic, paper, nylon mesh,
etc.) is not much, finish work only needs 30 minutes.
3. Large capacity
The device diameter is 630mm, height is2.2M, sand removal capacity
is up to 460 liters. For example 2X3M tank, clear 3-4 cans, you can
continue to use.
4. thick steel plate, perfect hydraulic system
The device uses 8mm thick steel tank ,in the tank internal
integration of advanced water-sand separation system. Base is made
of 20mm thick steel plate, durable. Switch door manual hydraulic
system, and a safety bolt that door switch and sealing easy, safe
5. powerful, stable
The device uses the most advanced pneumatic fluid pump, driven by
the high-pressure gas can generate a steady stream of high-pressure
water, provide the impetus for rapid Desanding
6. Energy Saving
The device does not process the whole Desanding loss of water in
the tank, no waste water.
Note: 1, the gas source required 12mm diameter pipe, the gas
pressure to 0.4 ~ 0.8MPa, gas supply must be greater than 0.6m³ /
2, before remove sand, the system much be filled with water.After
finish work, the water go into the tank and the waste sand go into
the removing system.
Please touch the picture to check the video of how it works.