Sign In | Join Free | My entremaqueros.com
entremaqueros.com
Products
Search by Category
Home > Finger Jointer >

Jointing Compound

Categories gypsum board ceiling system
Sample Price: Depending on the price changes of raw material
Delivery Time: within 2 working days(depends on your quantity)
Model Number: Jointing Compound
Place of Origin: china
Category: Eye Cream
  • Haven't found right suppliers
  • Our buyer assistants can help you find the most suitable, 100% reliable suppliers from China.
  • And this service is free of charge.
  • we have buyer assistants who speak English, French, Spanish......and we are ready to help you anytime!
  • Submit Buying Request
    • Product Details
    • Company Profile

    Jointing Compound


    Used in the gaps between the plasterboard.
    Packing Size:

    5kg or 10 kg per bag.
    Packing Bag Size:
    20x16x17cm
    Product Informaiton.

    Used for plaster wallboard finishing and texturing. Do not mix with other material.

    If the joint compound is dry,carefully add water to read the desired consistency.The best way is 1kg jointing compound with 550ml water.

    1 Apply the compound into any gap between the boards and fill the taper.Cut a piece of tape and press into the joint.cover the tape with the compound,and remove the redundtant,make sure the joint keep the same level with the surface,the first joint’s width is 100-120mm.

    2 After the first coat is set and and dried apply a further coat,extending 50mm to 60mm on each side.Ensure that the coat is tight and featured into the board surface.

    3 Once the second coat is set and dried apply a final coat extending 50mm to 60mm on each side ,ensure that it is tight and featured into the board surface.

    4 After the final coat is set and dried ,the joint should be lightly sanded using 120 grit paper held in hand or pole sander.

    APPLICATION:

    The compound should not be used in temperatures above 45?? or below 0??.It must be applied over every wallboard joint.To ensure an adequate adhesion of the compound the tape must be firmly pressed against the board using a hammer head joint knife,uniformly distributing the compound.Likewise,apply multi-used compound over screw heads and plastic or metallic corners.To obtain better results,apply two or three compound layer over the tape.Clean excess compound off the board before it dries.Make sure that dry compound does not come into contact with the remaining mixture.

    PRODUCT DETAILS:

    Packing:In SH-F Bag

    State: Powder

    Stocking:Store off the ground and in a dry environment,for the one haven’t used off seal to store.

    WARNINGS

    When mixed with water,this material hardens and becomes very hot sometimes quickly.Do not attempt to make a cast enclosing any part of the body using this material.Failure to follow these instructions can cause severe burns that may require surgical removal of affected tissue or amputation of limb.Dust can cause eye,skin,nose,throat or respiratory irritation.Avoid eye contact and inhalation of dust.Water eye protection.If eye contact occurs flush thoroughly with water.If dusty,water a NIOSH/MSHA approved respirator.Prolonged and repeated exposure to respirable crystalline sillica can cause lung disease and/or lung cancer.Use proper ventilation to reduce dust exposure.Do not ingest.If ingested call physician.

    Quality Jointing Compound for sale
    Send your message to this supplier
     
    From:
    To: Baier international company Ltd
    Subject:
    Message:
    Characters Remaining: (0/3000)
     
    Find Similar Products By Category:
    Inquiry Cart 0

    Home| Products| Suppliers| Quality Suppliers| Site Map |About Us |Contact Us |Help |关于我们 |联系我们

    Copyright © 2009 - 2019 entremaqueros.com. All rights reserved.